Do-It-Yourself Display Case Materials Needed (fig.1): • Hammer • Wood Glue • Long Pin Punch • Sand paper (120 grit) • Scissors • Small drill screw driver • Stain or sealer Materials Included (fig.2): • Wood frame side (3) • Pre-cut Plexi Glass • Plastic...
More
Do-It-Yourself Display Case Materials Needed (fig.1): • Hammer • Wood Glue • Long Pin Punch • Sand paper (120 grit) • Scissors • Small drill screw driver • Stain or sealer Materials Included (fig.2): • Wood frame side (3) • Pre-cut Plexi Glass • Plastic Dovetail pegs (6) • Metal Screws (6) • Plastic Retainer • Backer • Glass Clips • Flag/Star Backer NOT included* 1) Place glue on 45 (degree) joint top of wooden case (fig.3). Try to keep glue on outside of the dovetail slot to prevent glue from getting to the inside of the frame (fig.4) Place top wooden pieces together. Place dovetail peg (square side is top) in slot and drive to bottom using the punch to prevent damaging the wood with the hammer. Place second peg and drive ¼“ down so it is flush with the rabbit (fig.5). 2) Glue both sides of the bottom piece with frame upside down (fig.6). Place peg in router slot and drive to bottom with punch. Repeat on the other side then put a peg in each side drive in ¼” down with punch so it is f
Less